YOKOGAWA TE16*B Terminal Block Module

Configured for 16-channel analog and digital field signal termination in Yokogawa CENTUM VP/CS and ProSafe-RS control architectures, the YOKOGAWA TE16*B (TE16 Terminal Block Module) provides direct physical signal execution. It routes wiring from field transmitters and actuators directly to system I/O modules, maintaining signal path continuity inside industrial control cabinets.

Hardware Specifications

Channel-to-Channel Isolation and 4-20 mA HART Signal Conditioning

The TE16*B interface architecture facilitates structured cable distribution for 4-20 mA HART loop configurations and discrete digital lines across DCS and SIS platforms. Channel-to-channel isolation principles prevent ground loop currents from distorting precision analog process measurements during multi-point field deployments. The internal trace geometry maintains low loop impedance, suppressing electromagnetic noise coupling between adjacent termination points.

Frequently Asked Questions

Q: What conductor gauge range does the TE16*B terminal block accept?

A: The screw clamp terminals accept solid or stranded copper conductors ranging from 0.2 mm2 to 2.5 mm2 (AWG 24 to AWG 14).

Q: Can the TE16*B module handle mixed analog and digital field signals on the same terminal strip?

A: Yes, the 16 channels accommodate both 4-20 mA analog loops and low-voltage digital signals, provided proper physical separation guidelines are observed inside the wiring duct to prevent inductive coupling.

Q: Is external power required to operate the TE16B terminal block?

A: No, the TE16B functions as a passive termination assembly, conducting signal currents directly between field instruments and the system I/O interface without internal power draw.

Field Installation Guidelines

Disconnect all loop power sources and control cabinet main breakers before connecting field wiring to the TE16*B module. Secure the terminal block to the panel mounting plate or DIN rail using specified mechanical fasteners. Strip field conductor insulation to 7 mm and tighten screw terminals to a maximum torque of 0.5 Nm to maintain solid conductivity without damaging wire strands. Ground all cable shields at a single point on the main instrument ground bar. Maintain a minimum separation distance of 100 mm between low-voltage signal cables and high-voltage AC power lines.